I have Harman Kardon AVR 270 and it is not giving sound output. When i turned it on, something related to zones messed up i don't know why and now there's no sound.Please help
Share
I have Harman Kardon AVR 270 and it is not giving sound output. When i turned it on, something related to zones messed up i don't know why and now there's no sound.Please help
Sign Up to our social questions and Answers Engine to ask questions, answer people’s questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people’s questions & connect with other people.
Verified answer
It's quite easy to get mixed up with the Zone 2 stuff, especially if you're just prodding buttons with no real clue what you're doing. It's better to download a pdf of the user manual and just read through the steps in there about how to switch off Zone 2 and then use the remote to control the main zone only.
Here's the web page for that amp. Follow the link on the page to download the user manual. http://eu.harmankardon.com/harman-kardon-product-d...
If all else fails then the get-out-of-jail-free card is a system reset. Beware though, this will wipe all your settings out of the amp's memory so you'll have to do a full set up from scratch.
The following is cut and paste from the 270 manual.....
If the AVR behaves erratically after a power surge, first turn off the rear-panel Main
Power switch and unplug the AC power cord for at least 3 minutes. Plug the cord back
in and turn the receiver on. If this procedure doesn’t help, reset the AVR’s processor as
described below.
NOTE:A processor reset erases all user configurations, including video resolution,
speaker and level settings, and tuner presets. After a reset, reenter all of these settings
from your notes in the Appendix worksheets.
To reset the AVR’s processor:
1. Press the front-panel Standby/On switch to place the unit in the Standby mode (the
Power Indicator will turn amber).
2. Press and hold the front-panel Surround Modes button for at least 5 seconds until the
RESET message appears on the front-panel Message Display.
NOTE:After performing a processor reset, wait at least 1 minute before pressing any
Source Selector buttons
Harman Kardon Receiver No Sound